10mm Electric Drill

Product Detail

Product Description
Model:	HK-02
Rated Volatge:	220-240V
Frequency	50/60HZ
Rated Input Power:	300W
Drilling diameter:	1-10mm
No Load Speed:	0-2600R/min
G.W./N.W.:	16/15
Packing	34.5*26.5*52cm

 

Electric drill is the use of electric power drilling equipment. Is a conventional power tools products, but also the greatest demand for electric tools products. Electric drill only has a rotation mode, especially suitable for drilling in materials requiring a small force, such as cork, metal, brick, ceramic tile and the like.

best drill machine for home use mini electric Feature: 1.Soft grip 2.Practical belt clip 3.Forward/reverse operation 4.Variable speed preselection for adjusting to suit any application. 5.Compact design and low weight for easier handling when drilling rows of holes




Hand drill operating precautions:

1, check the power cord before use for damage. If so, it must be wrapped around the insulating tape, do not use the immersion and turmoil in the turmoil, can not touch the heat and corrosive media.

2, for the metal shell hand drill must take protective ground (then zero) measures.

3, before use to confirm the hand drill switch is off, to prevent the plug into the power outlet when the hand drill suddenly turns.

4, Drill before use should be idle 0.5 ~ 1min, check whether the transmission part is flexible, with no abnormal noise, screws and other loose, commutator spark is normal.

5, when drilling your hands grip the drill, try not to single-handed operation, should grasp the correct operating position.

6, can not use a notched drill bit, drill down the pressure when the pressure should not be too large, to prevent the drill interrupt.

7, clean the cutter waste, change the first move these knives, must be in the case of power off.

8, for small parts must use the clamp to clamp, then use the hand drill.

9, the operation into the drilling force can not be too large, to prevent the drill or silk attack flying out wounding.

10, before operation carefully check whether the drill bit cracks or damage, if found to have this situation, it should be replaced immediately.

11, pay attention to the direction of rotation of the drill bit and feed direction.

12, first turn off the power, such as the drill completely stop and then remove the workpiece from the tool.

13, do not immediately contact the drill bit after the workpiece is processed, so as not to overheat the drill may burn the skin.

14, before operation to carefully check whether there is a crack drill bit or damage, if found, should be replaced immediately.

15, the use of the commutator if found on the spark, drill overheating, you must stop using for inspection, such as removing dirt, replace the worn brush, adjust the brush holder spring pressure.

16, in order to avoid cutting fingers, during operation to ensure that all fingers evacuation of the workpiece or drill (wire tapping).

17, unplug the power plug when not in use. Drill should be stored in a dry, clean environment [